Power-Tec

15mm head for use with adjustable hinge handle for quickly and accurately fixing welded door hinge alignment problems. Even with door in place, the...

For use with a body hook, this block is ideal for getting a good pull in enclosed spaces and spreading the load of the pull.Square faced angled pul...

Double jaw clamp with a 3 tonne pull capacity (5 tonne when used in-line), can be used for any angle of pull all around the vehicle.120mm wide jaw....

Heavy slide hammer weighing 7.5kg (16.5lb), supplied with a variety of attachments allowing for heavier repair work and controlled hammering, inclu...

Shaft with fixing screws for use with the Power-TEC range of welded hinge adjusting heads.Length: 400mm.Part of Welding Hinge Adjusting Kits, Part ...

Used to join or shorten chains, suitable for bodywork and chassis pulling applications.Useful for shortening chains.Double hook allows the joining ...

A floor plate puller with four chain fixing positions for bolting to the workshop floor, suitable for bodywork and chassis pulling applications.Siz...

Easy, fast and reliable method of pulling MacPherson suspension strut towers to correct chassis dimensions to factory specifications.Developed to c...

J shaped pull hook with a 6 tonne capacity, for use with body pulling equipment.65mm wide.Pull capacity: 5 tonne.Complete with eyelet for chain hoo...

For use with Tack 'n' Pull, Part No. 91893, and a pulling system, these weld on plates are ideal for allowing hard to hold pulls.Size: 75 x 75mm.Pa...

For use with Tack 'n' Pull, Part No. 91893, and a pulling system, these weld on plates are ideal for allowing hard to hold pulls.Size: 25 x 75mm.Pa...

Low profile clamp with a 38mm jaw and 3 tonne pull capacity, ideal for hard to pull areas.38mm wide jaw.For chassis ends, supports, light openings ...

Single jaw clamp with a 2 tonne pull capacity (3 tonne when used in-line), features a 40mm jaw and 2 pulling eyelets meaning that it can be used fo...

Excellent for general pulling. Webbing body straps avoid marking and causing additional damage, and can be used in a variety of pulling situations,...

Designed for pulling and anchoring parts where access is limited.Circumference: 2m.Width: 25mm.Complete with 20cm protection sleeve.3 tonne breakin...

Robust pull clamp featuring 45mm wide jaws and a 5 tonne pull capacity, for use with body pulling equipment.45mm wide jaw.5 tonne pull capacity.Com...

Robust pull clamp featuring 100mm wide replaceable jaws and a 6 tonne pull capacity, for use with body pulling equipment.100mm wide jaw.6 tonne pul...

Robust scissor clamp with 3 tonne pulling capacity and 50mm jaws.50mm wide jaw.3 tonne pulling capacity.Painted finish for protection.Manufactured ...

Ideal for removing slight dents and creases in wheel arches. Simply hook under lip of wheel arch for pulls without bulging or mis-shaping the panel...

Ideal for removing slight dents and creases in wheel arches. Simply hook under lip of wheel arch for pulls without bulging or mis-shaping the panel...

A pull hook set with both small and large pull plates, and an adaptor for a 10 tonne body kit, for reaching over wide obstructions, making this ide...

60mm Self-locking clamp with deep reach. Speed-up pulls and save valuable hook-up time by eliminating the need to bolt the clamp to the panel.60mm ...

Compatible with jigs and pullers, this down pulley can be used to convert a direct pull into a downward pull.Converts a direct pull into a downward...

This Pulling Clamp from Power-TEC has a 35mm wide jaw and is small enough to be used in hard to reach, tight areas, yet it still boasts a 4 tonne p...