Routing

Trend GAUGE/D60 Digital depth gauge for router tables and saw benches. Horizontal and vertical measuring, ideal for hand routers, router tables and...

The world's fastest professional worktop scriber tool. It completes traditional scribing chores with precision, speed and ease. Quick and easy-to-...

The jig requires a router fitted with a 30mm guide bush and 12mm diameter long reach cutter. For most common sash mortice and dead locks with up t...

The Trend MS/PRO Multiscribe Profile Matching Tool scribes internal and external curves, marks parallel lines with fast, easy adjustable backset to...

The Trend Loc Block consists of four interlocking gripping blocks that lock together to allow the workpiece to be held in place when sanding, drill...

The Trend CR/DWS/F4/FC is a 4 inch double sided diamond stone with folding handle and monocrystalline diamonds for fast, clean, stock removal which...

Pin guided rounding over cutters are ideal for panel work and edge mounting, all can be used on natural timbers, man-made particles and fibre board...

The Trend CRT/MK3 CraftPro Router Table has a large, laminated MDF table and a quick-release aluminium extrusion back fence with sliding MDF cheeks...

Bead Cutters are ideally suited to form straight or curved decorative edge mouldings on table tops, chair legs and frames. They can also be used t...

Bead Cutters are ideally suited to form straight or curved decorative edge mouldings on table tops, chair legs and frames. They can also be used t...

Bead Cutters are ideally suited to form straight or curved decorative edge mouldings on table tops, chair legs and frames. They can also be used t...

Pin guided rounding over cutters are ideal for panel work and edge mounting, all can be used on natural timbers, man-made particles and fibre board...

The Trend Anglefix is a must have accessory for quick, accurate mitre saw setup when cutting mitres. It is simple to use, the desired angle is take...

The Trend CDJ300 Craft Dovetail Jig is accurate and easy-to-use for a variety of elegant dovetail joints. It cuts 12.7mm (1/2in) wide half blind do...

Trend Craft Pro Bearing Guided Corner Bead for attractive edge moulds. A full corner bead can be produced by making a second pass at 90°. With two ...

Trend Craft Pro Dovetail Cutters are designed for use with commercial dovetailing and stair housing jigs. They are also used to produce sliding and...

The Trend CB Counterbore is extensively used for recessing bolt and screw heads and is supplied with a HSS slow spiral drill bit. Fully adjustable,...

Holds door while drilling and fitting locks. No set-up time needed. No more searching and alternative door stops. Padded to prevent door and floor ...

The Trend CraftPro Bearing Guided 3° Undercut Router Bit has a shank-mounted bearing guide for routing a leading edge on doors to allow a tight fit...

Replacement bearing to suit all Trend bearing guided router cutters. The Bearings are shielded to prevent penetration of dust and grease packed fo...

Trend collet reduction sleeve, used to reduce the collet size to take cutters with smaller shanks. Should only be used as a stop-gap, as the correc...

Hard-wearing carry case for protecting and carrying the Trend COMBI1001, COMBI1002, KWJ700 and KWJ900.

The Trend Solid Tungsten Carbide two flute cutters are turned, milled and ground from a solid piece of Tungsten Carbide and provide the greatest du...

The Trend RB/B is a spare Replacment solid carbide Rota-Tip Blade to suit Rota Tip Cutters. Specifications: Length. 49.5mm.Width. 12mm.Thickness:...