Engine Tools

2-Piece impact ball joint splitter with detachable fork for use with Sealey air hammer guns. Long shaft provides reach and stability when striking ...

Forged steel body with phosphate finish. Suitable for most small cars and light vans.Forged steel body with phosphate finish. Suitable for most sma...

Drop-forged and heat treated alloy steel. Suitable for applications with awkward or limited access.Drop-forged and heat treated alloy steel. Suitab...

Chemically blackened forged steel body with thrust bolt. High strength construction, suitable for commercial vehicle ball joints.Chemically blacken...

Chemically blackened forged steel body with thrust bolt. High strength construction, suitable for splitting commercial vehicle ball joints.Chemical...

Low profile set suitable for most modern vehicles. Three sizes of jaw allow use on most cars and light commercial vehicles. Features heavy-duty for...

Forged steel body, ball joint splitter suitable for light commercial vehicles. Specially designed to be operated manually or by 1.5 Tonne hydraulic...

Heavy-duty ball joint splitter suitable for commercial vehicles. Specially designed to be operated manually or by 10 Tonne hydraulic ram (supplied)...

Chemically blackened forged steel body with thrust bolt. Suitable for commercial applications.Chemically blackened forged steel body with thrust bo...

Heavy-duty ball joint splitter with interchangeable jaws. Enables operator to select correct jaw size without taking entire splitter to the vehicle...

Suitable for removal and installation of spring and shock strut from steering knuckle. Prevents expensive damage to aluminium or cast iron steering...

Designed to remove and install press-fit rear suspension ball joints in situ, on BMW 5 and 7 Series. These joints are sometimes referred to as 'bus...

Suitable for the in situ removal and installation of front lower ball joints on Mercedes W220, W211, W230 and Renault Megane. No need to disassembl...

Suitable for removing and installing the upper front ball joint in situ without the need to disassemble. Features various adaptors used in differen...

Multipurpose ball joint dust covers easily replace split or damaged dust covers on otherwise serviceable ball joints, avoiding MOT test failure. Pa...

Heat treated alloy steel socket. 35mm Hex drive with 19mm internal clearance for OEM and non-OEM fittings. 50mm Ring with drive pegs which locate i...

Multipurpose ball joint dust covers easily replace split or damaged dust covers on otherwise serviceable ball joints, avoiding MOT test failure. Pa...

Set of two heat treated alloy steel sockets. Suitable for removal of OEM and aftermarket lower ball joints on Citroen and Peugeot vehicles. Supplie...

Suitable for a range of Citroen, Peugeot and Toyota vehicles. Design allows the suspension joint centre to pass through. 38mm 6-point Drive.Suitabl...

60mm Long, high carbon steel punches. Hardened, tempered and chemically blackened. Full set of alpha-numeric characters including the ampersand sym...

66mm Long, high carbon steel punches. Hardened, tempered and chemically blackened. Full set of alpha-numeric characters including the ampersand sym...

Hardened, tempered and fully polished Chrome Vanadium steel punches. Supplied in tool roll.One of a comprehensive range of Premier Hand Tools, suit...

73mm Long, high carbon steel punches. Hardened, tempered and chemically blackened. Full set of alpha-numeric characters including the ampersand sym...

Chrome Vanadium steel stock hardened and heat treated. Chemically blackened for corrosion resistance. Supplied in pouch.Chrome Vanadium steel stock...